DURKOPP ADLER Class 271 - 8.1.3 Displaying and Changing the Number of Bartack Stitches at the DA40 MS02 Controls

To Next Page

To Previous Page

8.1.3 Displaying and Changing the Number of Bartack Stitches at the DA40MS02

Controls

Prerequisites:

–

The mains switch is turned on.

–

The pedal is in base position.

–

Sewing is not taking place.

–

The display mode 1 is turned on (see Chapter 8.1.2).

Display:

Display mode 1: Number of bartack stitches

NumberMeaning Change via:

1 Number of forward stitches in the beginning bartack V+ or V- key

3 Number of reverse stitches in the beginning bartack V+ or V- key

5 Number of reverse stitches in the end bartack V+ or V- key

7 Number of forward stitches in the end bartack V+ or V- key

8 Current programming level Chapter 8.1.7,

8.1.8, 8.1.9

Programming:

–

Press the C>> or C<< key, a number blinks.

–

Press the V+ key, the value of the blinking number is increased.

–

Press the V- key, the value of the blinking number is decreased.

–

Press the C>> or C<< key until the number to be changed blinks.

–

Press the V+ or V- key until the desired value is set.

–

Press the M+ or M- key, the blinking is ended, the change thus saved.