DURKOPP ADLER Class 271 - 8.2.8 Changing the Direction of Rotation with the OC-TOP Control Panel

To Next Page

To Previous Page

8.2.8 Changing the Direction of Rotation with the OC-TOP Control Panel

Attention! The direction of rotation is correctly set at delivery .

–

Activate the special level (C) (see Chapter 8.2.6).

–

Change the parameter value <800>

–

Exit the special level (C) (see Chapter 8.2.6).

ATTENTION!

All needle positions must be set again after a change in the

direction of rotation. See Chapter 8.2.7.