DURKOPP ADLER Class 271 - 7.2.3 Meanings of the Symbols in the V810 Control Panel

To Next Page

To Previous Page

B Needle high/low no display

or shift function in the programming mode.

By pressing the key, a needle

movement is conducted which can be

programmed with parameter 140. See

Instructions manual, table chapter 6.16.

In the programming mode the

key has a different function. See

Chapter 7.2.6.

P Programming mode on/off Parameter number/Standard display

See Chapter 7.2.4 and 7.2.6

E Change-over from the parameter number to the Parameter number/Parameter value

value of the parameter.

Confirmation of the parameter value and

advance to the next parameter.

See Chapter 7.2.4 and 7.2.6

+ Increase of the value shown The displayed value is increased

in the programming mode

- Decrease of the value shown The displayed value is decreased

in the programming mode

7.2.3 Meanings of the Symbols in the V810 Control Panel

Symbol Function Display

C Automatic speed activated Symbol on

Only with automatically conducted

seam runs.

D Light barrier turned on Symbol on

E Sewing drive turned on Symbol on

F Speed limitation activated Symbol on

G Bobbin thread monitor turned on Symbol blinks

when the bobbin nears empty.