DURKOPP ADLER Class 271 - 8.1.7 Changing Parameters in the Operator Level (A) in the DA40 MS02 Controls

To Next Page

To Previous Page

8.1.7 Changing Parameters in the Operator Level (A) in the DA40MS02 Controls

Prerequisite:

The mains switch is turned on, the pedal is in the base position, sewing is

not taking place, the display mode 4 is turned on (see Chapter 8.1.2)

Display

Display mode 4: Parameter and parameter value

Number Meaning Change via:

1-3 Parameter V+ or V- key

4 Programming level -

5-8 Parameter value V+ or V- key

Selecting parameters and changing the parameter value.

–

Press the C>> key, the number 1 in the display blinks, sewing is not longer

possible.

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased.

–

Press the C>> key, the numbers 2-3 in the display blink.

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased .

–

Repeat this procedure until the numbers 1-3 show the desired parameter value.

–

Press the C>> key, the numbers 5-8 in the display blink (parameter value).

–

Press the V+ key, the value of the blinking number is increased or

Press the V- key, the value of the blinking number is decreased .

–

Repeat this procedure until the numbers 5-8 show the desired parameter value.

–

Press the M+ or M- key, the blinking is ended, the change is thus saved, sewing is

possible again.