DURKOPP ADLER Class 271 - Connection to the DA40 MS02 Controls

To Next Page

To Previous Page

6.3.2 Connection to the DA40MS02 Controls

–

Screw off the control cabinet.

–

Guide the cable of the sewing light transformer through the opening 1 at the back

of the controls.

–

Loosen screw 2 and remove cover 3.

–

Lay the cable through the guide 4.

–

Open terminals 5 and 6 with a screwdriver.

–

Connect the brown cable to terminal 5 and the blue cable to terminal 6.

–

Replace cover 3 again and fasten with screw 2.

–

Screw the control cabinet tight again.

4 5 6

1 2 3