DURKOPP ADLER Class 271 - 8.2.10 Master Reset with the OC-TOP Control Panel

To Next Page

To Previous Page

8.2.10 Master Reset with the OC-TOP Control Panel

All parameter values changed in relation to the preset values are reset to the preset

values by a master reset.

ATTENTION!

At a master reset several parameters such as e.g.

<700-707>

(needle position),

<799> (

selected machine

class) and

<800>

( (motor direction of rotation) are not

reset.

After a master reset all machine-specific parameters

must be set as per the parameter sheet again. See

Chapter 8.2.9.

Preparing the master reset

–

Turn the main switch off.

–

Step the pedal completely forward and hold in this position.

–

Press the keys P+ or P-, S+ or S- and L+ or L- at the same time and hold down.

–

Turn the main switch on.

–

Release the the three keys and bring the pedal into base position.

–

The display shows:

Conducting a master reset

–

Press the P+ key below the "

" (yes) indicator.

–

The master reset is initiated. If the master reset is not to be carried out, then the L+

key below the "

" (no) indicator must be pressed.

–

The display briefly shows:

Then the display briefly shows the initialization display e.g.:

and then the display appropriate to the selected work mode.