Sewing sequence Operation / Remarks
At the middle of the seam
Interrupting the sewing sequence
Sewing a corner
Continuing the sewing sequence
(after release of the pedal)
Sewing an intermediate bartack
- Release the pedal (rest position) .
The machine stops in the 1
st
position
(needle down).
The sewing foot is down.
- Step the pedal half back.
The machine stops in the 1
st
position
(needle down).
The sewing foot is lifted.
- Turn the material around the needle.
- Step forward on the pedal.
The machine sews at the speed
determined with the pedal.
- Press key 2 and hold the pedal down.
The machine sews in reverse as long as key 2
is pressed.
The speed is determined by the pedal.
At the seam end
Ending the seam
Ending the seam
without an end bartack
- Step completely back on the pedal and hold down.
The end bartack is sewn.
The thread is trimmed.
The machine stops in the 2
nd
position.
The sewing foot is raised.
Remove the material.
- Press key 1 (bartack suppression).
Step completely back on the pedal.
The end bartack is
not
sewn.
The thread is trimmed.
The machine stops in the 2
nd
position.
The position of the sewing foot is dependent
on the position of the pedal:
a) Pedal stepped back and held down:
- Sewing foot raised.
b) Pedal released (rest position):
- Sewing foot down.
GB
31
To Next Page
Loading...