4 Replacement Procedures 4.6 SPEAKER
4-26 [CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
Installing the SPEAKER
To install the SPEAKER, follow the steps below and refer to 4-6 to 4-8.
NOTE: Prepare SPEAKER for non 5G/LTE model, SPEAKER 5G for 5G and LTE
model.
<SPEAKER> <SPEAKER 5G>
1. Set the SPEAKER or SPEAKER 5G (left and right) to the slots of the COVER
ASSY.
2. Arrange the SPEAKER HARNESS in place and fix it with the INSU KB LOW or
INSU KB LOW 5G.
3. Connect the SPEAKER HARNESS to the connector CN6290 on the SYSTEM
BOARD.
4. Connect the FP FFC (finger print sensor model) and CPAD FFC to the connectors
CN9550 and CN9510 on the SYSTEM BOARD.
5. Connect the marked side of the FP FFC (finger print sensor model) and CPAD FFC
to the connectors on the CLICK PAD.
Cushion
AL TAPE for shielding
Different form and number of cushions
Rev.01
To Next Page
Loading...
