3 Tests and Diagnostics
3-36
[CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
3.17.3 Start and Test procedure
Procedure 1: Write the DMI information with the test program for maintenance.
Procedure 2: Insert the USB memory created in the preparation step into the USB
connector.
Procedure 3: Turn on the computer while pressing F12 to display the screen to select a boot
device.
Procedure 4: Chose USB device on the selection screen, and press Enter. Then the
calibration tool appears (below is the sample screen).
Procedure 4: Remove the USB memory.
Procedure 5: Change the PC to be tested into Tablet style and lay it on the horizontal and
stable table as the screen faces up.
Procedure 6: Touch “Start Test Now“ button to start the test.