GBK60348: Issue 3 23
2.5.7 ECU2 Mode – Standard
ECU2 Mode gives access to channel 7 and 8 of an ECU Module that has been setup
as ECU1, and to all 8 channels of an ECU Module that has been setup as ECU2.
The 8 channels of ECU2 are numbered 9-16.
Note:
This mode is only available if one of the ECU Menu parameters (see 4.2.1.9) is
set to 'Yes' and an ECU Module is detected in the system.
Only the enabled channels will be shown.
Deflecting the joystick forward or reverse toggles
the selected channel: when the channel is off,
it turns on, when the channel is on, it turns off.
If the joystick is deflected reverse, the channel
will stay in the new state (on or off) when the
joystick is returned to neutral (latched operation).
If the joystick is deflected forward, the channel
will return to its original state when the joystick
is returned to neutral (not-latched operation).
iPortal Accessory Mode – Standard
iPortal Accessory Mode – Standard
The function keys scroll through the available channels.
Rotate the orientation of
the joystick with Accessory
Menu Navigation (4.2.1.6).
Toggle selected
channel - not latched
Toggle selected
channel - latched
To Next Page
Loading...
Need help?
General
