74 GBK60348: Issue 3
5.7 Electromagnetic Compatibility (EMC)
Dynamic Electronic Controllers have been tested on typical vehicles to confirm
compliance with the following appropriate EMC standards:
USA: ANSI/RESNA WC/Vol:2 - 1998 Sec 21
Europe: EN12184: 1999 Sec 9.8.1-3
National and international directives require confirmation of compliance on
particular vehicles. Since EMC is dependent on a particular installation, each
variation must be tested.
Minimising emissions
To minimise emissions and to maximise the immunity to radiated fields and ESD,
follow the general wiring recommendations in section 2.1.1 of the DX System Manual.
5.8 Environmental statement
This product has been supplied from an environmentally aware
manufacturer.
Please be environmentally responsible and recycle this product at
the end of its life through your local recycling facility.
This product may contain substances that could be harmful to the
environment if disposed of into a landfill.
To Next Page
Loading...
Need help?
General
