Dynamic DX2-REM550 User Manual

GBK60348: Issue 3 11
2.3 Turning the DX System on and off with the AJR
To turn on the DX System
Press the power button.
 The AJR will beep twice (if the Mode Change Beep parameter,
see 4.2.1.10, is set to ‘Yes’) and the system will start up in
Drive Mode (see 2.5.1) with the Drive Profile that has been set with the
Power-Up Profile Number parameter (see 4.2.1.13).
To turn off the DX System
Press the power button.
 The DX System will turn off.
Note:
If the power button is pressed while the chair is driving,
the chair will perform an emergency stop before it turns off.
2.3.1 System Lock
If the Lock Enable parameter (see DSM section 5.3.9.7) is set to 'Yes', the
system can be locked by pressing the power button for more than
4 seconds.
To lock the DX System
Press the power button for 4 seconds when the DX System is turned on.
 The DX System will turn off in a locked state.
To unlock the DX System
Press the power button.
 The AJR will show a lock on the display.
Press the horn button twice within 10 seconds.
 The DX System will turn on normally.
2.3.2 Sleep mode
If the Sleep Mode Enable parameter (see DSM 5.3.9.8) is set to 'Yes', the
DX System will go to sleep after a period of inactivity. This period can be set
with the Sleep Timeout parameter (see DSM 5.3.8.5). When the DX System
sleeps, it is partially turned off to reduce energy consumption.
To wake up the DX System
Any key
or
Joystick
Press any button on the AJR, or, if the Enable Joystick Wakeup parameter
(see DSM 5.3.9.10) is set to 'Yes', move the joystick.
 The DX System will turn on.
2 x

Dynamic DX2-REM550 Specifications

General

Brand	Dynamic
Model	DX2-REM550
Category	Video Game Controller
Language	English