GBK60348: Issue 3 61
Reversing Beeper 4.2.1.11
If this parameter has the value 'Yes', the AJR will produce an audible beep once a
second while the powerchair drives in reverse.
Indicator Auto Cancel 4.2.1.12
Off - After the indicator lights are switched on, they will stay on until the user
switches them off.
5-20 - After the indicator lights are switched on, they will automatically switch off
after Indicator Auto Cancel seconds.
Power-Up Profile Number 4.2.1.13
Last used Profile
Profile 1 – 5
Profile 0 (see
note below)
The Power-up Profile Number is the Profile in which the DX System will start when the
system is switched on. If Power-up Profile Number is set to 'Last Used Profile', the DX
System will start up with the same Drive Profile that was active when the DX System
was switched off.
Note: Since the introduction of software version 2.03, Profile 0 is no longer permissible as a possible value. If
this is selected, it will automatically default to Profile 1.
Return To Last Menu 4.2.1.14
If set to 'No', the Remote will power up into the Drive Menu. If set to 'Yes' and the
Remote was in an Accessory Menu when it powered down, then the Remote will
return to that Accessory Menu on power up.
This feature is only available on DX2 Master Remotes manufactured with serial
numbers I13xxxxxx or later, and older DX2 Master Remotes will always power up in the
Drive Menu.
To Next Page
Loading...
Need help?
General
