44 GBK60348: Issue 3
4 Programming the AJR
Warning:
The DX2 AJR is part of the DX System. Read the DX System Manual
programming chapter (DSM chapter 7) including all its warnings and
notes before reading this chapter. The programming chapter of this
AJR manual only describes AJR-specific programming.
The XLR programming / charger socket is located at the back of the AJR. To use this
socket with the HHP or the PC-Wizard programming cable, a DWIZ-ADAPT adapter
plug is needed.
The DX2 AJR is the first DX Master Remote that uses UCM Rev. D software (for software
revisions see DSM section 5.1.1). This revision adds several system parameters and
AJR-specific parameters.
To Next Page
Loading...
