HEALTH AND SAFETY
1-4 25364 Issue 8 March 2018
ALWAYS disconnect the power to the machine before removing any service
covers. The power connector to the back of the printer must be removed.
The Communicator II printer’s mains plug must be removed from the mains
power supply.
ALWAYS keep hands and loose clothing away from the print head opening
whilst the printer is powered on, as there is a danger that the mechanism
will move without warning and present a crushing hazard.
DO NOT operate the machine with any covers removed. ALL covers must
be in place using the appropriate number of fasteners. It is essential that
electrical and non-electrical connector dust covers (provided with the
machine) are fitted to all unused connectors to protect against dust and dirt
and possible static damage to internal components.
Ensure all reasonable safety precautions have been undertaken. However,
please ensure that when working with / or around the machine, every care
is taken to avoid potential hazards. ALWAYS take great care around the
machine not to slip, trip or fall; especially if the machine is used in areas
where the floor may be wet or greasy.
Use only Easyprint ribbons.
Replace ribbons with care to avoid cutting hands or fingers.
Take care, in the unlikely event of an electronic fault causing an unexpected
start up of printer drive motors, to avoid possible injury.
Read the Safety Data Sheet (SDS) for Cleaning Fluid (P/N WJ-111) before
using it with any Easyprint product.
There is a danger of electrical shocks from the electrical outlet. All
electronic checks must be performed by qualified personnel.
The information above is correct to the best of our knowledge, information
and belief at the date of this publication. The information given is designed
only as guidance for safe handling use, processing, storage, transportation,
disposal and release and is not considered a warranty or quality
specification. The information relates only to the specific material
designated and may not be valid for such material used in combination with
any other materials or in any process unless specified in text.
To Next Page
Loading...
