6 Parameters
6.3 Operational data indicator
138 DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com
Example: Status displays
The status displays of the digital inputs and outputs are equivalent. They can
be used to check whether an output control signal (e.g. from an external con-
troller) activates the frequency inverter’s inputs (DI1 to DI4). This provides
you with an easy way to check the wiring (wire breakage).
The following table shows a few examples.
Display value:
• 1 = activated = High
• 0 = not activated = Low
P00-17 ro 0 - 2 x rated
operational
current
Motor current
The eight most recent values before the trip
Updated every 250 ms.
P00-18 15 ro – Software version
16 Version number and checksum
1 = I/O processor (on the left side)
2 = motor control
P00-19 ro – Serial number of frequency inverter
The frequency inverter’s unique serial number
Example: 540102 / 32 / 005
P00-20 12 ro – Frequency inverter part no.
13 Rated power of frequency inverter
14 Frequency inverter type (example: 0.37, 1 230, 3P-out)
PNU ID Access rights Value Description DS
RUN ro/rw
PNU ID Display value Description
P00-04 11 0000 No digital input (DI1, DI2, DI3, DI4) is actuated
1000 Control signal terminal 2 actuated (DI1)
0100 Control signal terminal 3 actuated (DI2)
0010 Control signal terminal 4 actuated (DI3)
0001 Control signal terminal 6 actuated (DI4)
0101 Control signal terminals 3 and 6 actuated (DI2 + DI4)
To Next Page
Loading...
