118
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Rear Housing Assembly Disassembly/Assembly | Disassembly/Assembly TRSM0950
Procedure – Disassembly
1. Perform “Rear Bearing Cover Removal” on page 45.
2. Place Rear Housing on Rear Housing Stand
(RR1069TR).
WARNING: Rear Housing weighs approximately 170
lbs. Keep fingers clear of pinch point between Rear
Housing and other surfaces. Dropping Rear Housing
may result in major vehicle component damage, severe
injury or death.
3. Remove Rail E Detent Plug with a 6 mm hex key.
Note: Detent Plug is under spring pressure.
4. Remove the Rail E Spring and Detent using a magnet.
To Next Page
Loading...
