2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
119
TRSM0950 Disassembly/Assembly | Rear Housing Assembly Disassembly/Assembly
5. Remove 4 Reaction Plate 13 mm cap screws and
washers.
6. Install 2 Reaction Plate Alignment Pins (RR1091TR)
onto Reaction Plate dowels.
NOTICE: Failure to use Reaction Plate Alignment Pins
(RR1091TR) results in component damage.
7. Install Range Assembly Removal & Installation Tool
(RR1065TR) into Sun Gear groove.
CAUTION: Failure to properly secure tool could result
in damage to component(s) or personal injury.
NOTICE: Fully seat tool into groove and hand tighten
until tool is secure.
!
To Next Page
Loading...
