2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
125
TRSM0950 Disassembly/Assembly | Rear Housing Assembly Disassembly/Assembly
13. Place rear housing on Rear Housing Stand
(RR1069TR).
14. For Dual PTO Transmissions, install Rear PTO Lube
Tube and 8 mm cap screw into Rear Housing and
torque to 8.8 - 10.4 Nm (6-8 lb-ft).
15. Install Reaction Plate Alignment Pins (RR1091TR) in
Rear Housing.
NOTICE: Failure to use Reaction Plate Alignment Pins
(RR1091TR) results in component damage.
16. Inspect plastic Oil Slinger to ensure it is locked into
place by three locking tab pins.
To Next Page
Loading...
