2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
175
TRSM0950 Installation | Main Shaft and Countershaft Installation
5. Slowly press down the Synchronizer Sliding Sleeve to
the neutral position and seat the 3 rollers evenly on the
springs and plungers.
6. Install Rail B Synchronizer Ring.
Note: Align the 3 tabs on ring to the 3 openings on the
hub at each spring and plunger.
7. Install Wave Spring - Front.
NOTICE: Wave Spring - Front is taller than the Wave
Spring - Rear.
8. Install Thrust Washer - Front.
9. Install Needle Bearing - Front.
To Next Page
Loading...
