2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
183
TRSM0950 Installation | Main Shaft and Countershaft Installation
34. Install Lower Countershaft Flat Washer and Snap Ring.
NOTICE: A new snap ring is required when reinstalling.
A used snap ring may detach from countershaft and
result in transmission component damage.
35. Perform “Lower Countershaft Cover and Inertia Brake
Installation” on page 143.
36. Install Input Shaft Snap Ring.
NOTICE: A new snap ring is required when reinstalling.
A used snap ring may detach from Input Shaft and
result in transmission component damage.
37. Perform “Input Shaft Cover Installation” on page 147.
To Next Page
Loading...
