Eaton Endurant - Main Housing Installation

182
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Shaft and Countershaft Installation | Installation TRSM0950
29. Install Upper Lube Tube into Clutch Housing and install
8 mm cap screw and torque to 8–10 Nm (6–13 lb–ft).
30. Install Lower Lube Tube into Clutch Housing and 8 mm
cap screw, torque to 8–10 Nm (6–13 lb–ft).
31. Perform “Main Housing Installation” on page 185.
32. Perform “Rear Housing Installation” on page 197.
33. Lift transmission horizontally onto a bench.
WARNING: Transmission weighs approximately 550
lbs. Keep fingers clear of pinch point between trans-
mission and other surfaces. Dropping transmission
may result in major vehicle component damage, severe
injury or death.
NOTICE: Use an appropriate lifting device to safely lift
component.
!