2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
181
TRSM0950 Installation | Main Shaft and Countershaft Installation
25. Install a magnet onto the Main Shaft Key.
Note: The magnet holds the key in position during
Main Shaft Assembly installation.
26. Slide and hold Rail C Sliding Clutch into Secondary
Driven Gear.
27. Install Main Shaft Assembly onto Primary Drive Gear
and align gearing.
CAUTION: Main Shaft weighs approximately 35 lbs.
Keep fingers clear of pinch point between Main Shaft
and other surfaces. Dropping Main Shaft could result
in component damage and/or personal injury.
28. Remove magnet from Main Shaft Key.
NOTICE: Ensure to remove magnet or component
damage may occur during assembly.
!
To Next Page
Loading...
