2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
195
TRSM0950 Installation | Oil Pump Installation
5. Install 18 Oil Pump Assembly 13 mm cap screws and
torque to 21–23 Nm (16–18 lb–ft) in a criss-cross pat
-
tern.
6. Perform “Rear Housing Installation” on page 197.
7. Lift transmission horizontally onto a bench.
WARNING: Transmission weighs approximately 550
lbs. Keep fingers clear of pinch point between trans-
mission and other surfaces. Dropping transmission
may result in major vehicle component damage, severe
injury or death.
NOTICE: Use an appropriate lifting device to safely lift
component.
8. Perform “Output Yoke Installation” on page 141.
9. Perform “Harness Bracket Installation” on page 203.
10. Perform “Output Speed Sensor Installation” on
page 161.
11. Perform “Mechatronic Transmission Module (MTM)
Installation” on page 151.
12. Perform “Transmission Control Module (TCM) Installa-
tion” on page 169.
13. Perform “Release Bearing and Clutch Release Yoke
Installation” on page 167.
14. Perform “Transmission Installation” on page 211.
Note: Complete all Service Routines or transmission
performance will be degraded.
To Next Page
Loading...
