2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
207
TRSM0950 Installation | Clutch Installation
Procedure – Installation
1. Install a new pilot bearing. Refer to OEM and/or engine
manufacturer installation guidelines.
2. Install 2 Alignment Pins (RR1063TR-3) into the fly-
wheel directly across from each other, at approximately
3 and 9 o’clock.
Note: Do not install the Alignment Pins into the center
threaded hole of the 3-threaded hole groups.
3. Install the Clutch Cover and Driven Disc onto the clutch
jack-mounted Clutch Alignment Shaft (RR1087TR).
WARNING: Clutch weighs approximately 125 lbs. Fail-
ure to properly secure the Clutch Alignment Shaft to
the clutch jack may result in clutch damage, severe
injury or death.
!
To Next Page
Loading...
