2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
209
TRSM0950 Installation | Clutch Installation
10. Torque Clutch Cover cap screws 1 through 12 to 57-67
Nm (42-50 lb-ft) as shown in the torque sequence
below.
11. Re-torque Clutch Cover cap screws 1 through 12 to
57-67 Nm (42-50 lb-ft) as shown in the torque
sequence below to verify clutch is fully seated to the
flywheel.
12. Remove the Clutch Alignment Shaft (RR1087TR).
13. Locate the 4 Control Fingers in the Clutch Cover.
14. Use a 6 ounce (170 gram) hammer and a 3/8 inch
(9.525 mm) brass pin punch and lightly tap the 4 con
-
trol fingers until they contact the flywheel.
CAUTION: Keep fingers clear to avoid personal injury.
CAUTION: Only use tools specified and do not use
excessive force to seat the control fingers to the fly-
wheel. If controls fingers are damaged during installa-
tion the clutch will not properly adjust and will require
replacement.
15. Perform “Input Shaft Pilot Bearing Wear Sleeve Disas-
sembly/Assembly” on page 81.
To Next Page
Loading...
