222
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Input Shaft Disassembly/Assembly using Input Shaft Press (RR1085TR) | Appendix TRSM0950
Procedure - Disassembly
1. Ensure Input Shaft Snap Ring is removed.
2. Place and support Clutch Housing on a bench.
Note: Allow space to press the Input Shaft out of
Clutch Housing.
3. Place Input Shaft Cup (RR1087TR-6) on the end of the
Input Shaft.
4. Place Input Shaft Press (RR1085TR) on the flywheel
housing side of the Clutch Housing.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch point between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
5. Install and hand tighten 4 (2 inch 7/16 inch Grade 8 or
50.8 mm M12 Grade 10.9) cap screws, washers and
nuts to attach press to housing.
!
To Next Page
Loading...
