2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
223
TRSM0950 Appendix | Input Shaft Disassembly/Assembly using Input Shaft Press (RR1085TR)
6. Place soft material under Input Shaft.
7. Rotate jack screw to press Input Shaft out of Clutch
Housing.
8. Remove 4 cap screws, washers, nuts and Input Shaft
Press (RR1085TR) from Clutch Housing.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch points between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
9. Place and support Clutch Housing on a bench.
10. Install Input Shaft Press (RR1085TR) on the Main
Housing side of the Clutch Housing aligning the 3
notches on the side of Linear Clutch Actuator opening.
CAUTION: Input Shaft Press weighs approximately 30
lbs. Keep fingers clear of pinch points between Input
Shaft Press and other surfaces. Dropping Input Shaft
Press could result in component damage and/or per
-
sonal injury.
NOTICE: Protect Clutch Housing to Main Housing seal-
ing surface from damage or an oil leak may occur.
11. Install and hand tighten 4 Main Housing to Clutch
Housing 16 mm cap screws in the inboard holes on
each side of the press.
!
To Next Page
Loading...
