Eaton Endurant - Page 74

2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
71
TRSM0950 Removal | Main Shaft and Countershaft Removal
26. Remove Needle Bearing - Rear.
27. Remove Bearing Race - Rear.
28. Remove Primary Drive Gear.
29. Remove Lower Countershaft.
CAUTION: Countershaft weighs approximately 35 lbs.
Keep fingers clear of pinch point between Countershaft
and other surfaces. Dropping Countershaft could result
in component damage and/or personal injury.
30. Remove Upper Countershaft.
CAUTION: Countershaft weighs approximately 35 lbs.
Keep fingers clear of pinch point between Countershaft
and other surfaces. Dropping Countershaft could result
in component damage and/or personal injury.
!
!