Eaton Endurant - Page 83

80
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Inertia Brake Disassembly/Assembly | Disassembly/Assembly TRSM0950
4. Install the inertia brake clutch pack in the order shown
below:
• 1 Steel Disc,
• 1 Friction Disc,
• 2 Steel Discs,
• 1 Friction Disc,
• 2 Steel Discs,
• 1 Friction Disc, and
• 1 Steel Disc.
Note: Steel Discs align with Wear Guides. Friction
Discs spline to the lower countershaft.
5. Place Inertia Brake Cover and Piston on the Housing.
Align the bolt holes.