2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
79
TRSM0950 Disassembly/Assembly | Inertia Brake Disassembly/Assembly
Procedure – Assembly
1. Insert the O-ring into the groove on the rear of the Iner-
tia Brake Housing until fully seated.
2. Insert the O-ring into the groove on the front of the
Inertia Brake Housing until fully seated.
3. Install the 2 Wear Guides in the Inertia Brake Housing.
To Next Page
Loading...
