Eaton Power Xpert 9395P - System Status Screen and Controls; Figure 7-24. User Log Screen; Figure 7-25. User Log Detail Screen

P-164000476 9395P 500kVA / 600 kVA 96
Revision 002 User’s and Installation Guide
• System Event Messages - When a system event occurs, a message appears on the LCD in the
UPS status area. This message is also written to the Active Events Log and may be added to the
History Log. The messages are divided into four categories: alarms, notices, status, and
commands.
The user log window (1) allows the operator to enter any number up to the number shown to the right
of the box. Each window shows five events. The operator can also use the UP/DOWN arrows above
and below the blue field (2) showing the number of events in the log. See the following figure.
Figure 7-24. User Log Screen
Selecting an event opens the Event Detail screen shown in the following figure. This screen details the
specifics of the event for the user to see.
Figure 7-25. User Log Detail Screen
7.3.13 System Status Screen and Controls
Press the SYSTEM CONTROLS pushbutton on the main menu bar to display the System Status screen.
Online operation, transfer to bypass, UPM start up and shutdown, and LOAD OFF commands are
controlled through this screen. In addition, the screen displays the current status of the UPS, indicates
whether the UPS is in Maintenance Bypass or Bypass, and displays the state of the UPM. The figure
below shows the System Status screen.