Eaton Power Xpert 9395P - Multiple UPS Distributed Bypass System Oneline Configurations

P-164000476 9395P 500kVA / 600 kVA 78
Revision 002 User’s and Installation Guide
6.5 Multiple UPS distributed bypass system oneline
configurations
The distributed bypass system oneline drawings in this section show the simplified internal structure of
the UPS, battery supply, and basic maintenance bypass in a multiple UPS configuration. These onelines
do not show each UPM in the UPSs, but represent each UPS in the distributed bypass system. The
internal structure of each UPS is shown in Figure 6-6 through Figure 6-9 starting on page 77.
NOTE
If the load requires a neutral, a bypass source neutral must be provided. If the load does not
require a neutral and there is no neutral conductor connected at the bypass input, a UPS neutral
must be connected to source star point.
Oneline Drawing UPS Model
Voltage
System Type
Input Output
Figure 6-14 on page 79
9395P 1100
400 400 Multiple UPS - Distributed Bypass 1+1 and 2+0
Configurations
Figure 6-15 on page 80 9395P 500 kVA 400 400 Multiple UPS - Distributed Bypass 2+1 and 3+0
Configurations
Figure 6-16 on page 81 9395P 600 kVA 400 400 Multiple UPS - Distributed Bypass 3+1 and 4+0
Configurations