Eaton Power Xpert 9395P - Lansafe Power Management Software; Terminal Mode; Figure 8-1. Optional X-Slot Cards

P-164000476 9395P 500kVA / 600 kVA 127
Revision 002 User’s and Installation Guide
Figure 8-1. Optional X-Slot cards
8.2 LanSafe Power Management Software
Each Eaton 9395P UPS ships with LanSafe® Power Management Software. To begin installing LanSafe
software, see the instructions accompanying the Software Suite CD.
LanSafe software uses an RS-232 serial link to communicate with the UPS. The software provides up-
to-date graphics of UPS power and system data and power flow, a complete record of critical power
events, and notification of important UPS or power information. With custom views for monitoring
status and metering information, various user groups can select the most useful view for their specific
needs. LanSafe Power Management Software
8.3 Terminal mode
Terminal mode is supported by all RS-232 serial communication ports of the UPS. The following
settings should be used:
• Baud rate:19200
• 8 data bits
• no parity
• 1 stop bit
NOTE
The brackets ([ ]) in the following bullets indicate standard keyboard characters. To use a key
combination, hold down the Escape key and press the indicated letter key.
A ConnectUPS-X Web/SNMP card
B Modbus card
C Relay interface card
D Modem card
E
Industrial relay card