Eaton PowerXL DH1 - Canopen External Communication Cards; Canopen Technical Data; Canopen Cable; Table 118. Canopen Connections

99
CANopen External Communication Cards
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
CANopen External Communication Cards
The Eaton PowerXL DG1 series drive can be connected
to the CANopen system using a fieldbus board. Through
this board the drive can be controlled, monitored and
programmed from the Host system. The CANopen fieldbus
board can be installed in either slot A or slot B on the
control board of the drive. The devices are connected in
abus structure. There is a maximum of 127 devices that
canbe connected to a single master. The bus termination
should be made on the end of the bus segment.
CANopen technical data
Table 118. CANopen connections
Item Value
Interface Open style connector (Pluggable connector)
Data Transfer method CAN (ISO 11898)
Transfer Cable 2 wire Twisted shielded cable
Electrical Isolation 500 Vdc
Table 119. Communications
Item Value
CANopen CiA DS-301, CiA DSP-402
Baud rate 1000 kBaud
800 kBaud
500 kBaud
250 kBaud
125 kBaud
50 kBaud
20 kBaud
Addresses 1–127
Table 120. Environment
Description Specification
Ambient Operation Temperature –10 °C to +55 °C
Storing Temperature –40 °C to +60 °C
Humidity <95%, no condensation allowed
Altitude Max. 1000 M
Vibration 0.5G at 9–200 Hz
Safety Fulfills EN 50178 Standard
CANopen cable
To meet the ISO 11898 standard, cables to be used with CANbus lines should have a nominal impedance of 120 ohms, a
line delay of 5 ns/m. Line termination has to be provided through termination resistors of 120 ohms on both ends of the
transmission lines. The length should be related to resistance at 70 mohm/m. There is a terminating resistor bank on all
boards and can be set via the DIP switch setting.
Below are the practical bus length for CANopen networks with less than 64 nodes.
Table 121. Practical bus length
Item Value
Baud Rate (kbits/s) 1000 800 500 250 125 50 20
Max. Bus Length in m 30 50 100 250 500 1000 2500