Eaton PowerXL DH1 - Option Card Slots; Figure 4. Powerxl Series Control Board Location; Figure 5. Count; Figure 5. Powerxl Series Control Board Location

3
Option Card Slots
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Option Card Slots
The control board is located inside the control unit of the
PowerXL Series Drive. There are two slots, labeled A and B,
on the control board. The different option boards can be
added to any slots. For more information, see “PowerXL
Series Option Board Summary.” When the PowerXL Series
Drive is assembled at the factory, no option boards are
installed in slots A and B. If an incorrect board is plugged
into either slot, the board will not work, but there is no
danger to personal or for equipment damage.
Figure 4. PowerXL Series control board location
Figure 5. Count
Figure 5. PowerXL Series control board location
Connect DSP Part
to Power Board
Keypad
Connect MCU Part
to Power Board
Battery (Standard)
RJ45 EtherNet/IP,
Modbus TCP
Optional Card A
Optional Card B
RS-485 Termination
Resistor
Removable
MOV Screw
Motor Ground
Clamp Location
Grounding
Strap Location
Grounding
Strap Location
Line Ground
Clamp Location
Removable
EMC Screw
Control I/O
Terminals
AI Mode Selection
STO
Fan Power Wire
Line Side Motor
ON
123
ON
1