135
Hardware specifi cation
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Network state machine
Figure 54. Network state machine
Start Forward, Start Reverse, Change to Forward, Change
to Reverse, and stop is static outputs of the Control
Supervisor state machine.
EDS file
EDS is the abbreviation for Electronic Data Sheet, a file on
disk that contains configuration data for specific device types.
You can provide configuration support for your device by
using a specially formatted ASCII file, referred to as the EDS.
The information in an EDS allows configuration tools to
provide informative screens that guide a user through the
steps necessary to configure a device. An EDS provides
all of the information necessary to access and alter the
configurable parameters of a device. This information
matches the information provided by instances of the
parameter object class. The CIP object library describes the
parameter object class in detail.
Explicit messaging
Explicit messaging is used in commissioning and
parameterizing the DeviceNet board and device. It is a tool
used to provide multi-purpose, point-to-point communication
paths between two devices. They provide the typical
request/response-oriented network communication used
to perform node configuration and problem diagnosis.
Explicit messages are low priority identifiers and contain the
specific meaning of the message right in the data field.
List of object classes
The communication interface supports the following object class.
Table 165. List of object classes
Class Object Remark
0x01 Identity objects Cip required object
0x03 DeviceNet object Cip required object
0x04 Assembly object CIP object for drive device
0x05 Connection object Communication object
0x28 Motor Data object CIP object for drive device
0x29 Control supervisor object CIP object for drive device
0x2A AC/DC drive object CIP object for drive device
0xA0~0xBB Vendor parameters object Vendor specific
0x96 Base device information object Vendor specific
To Next Page
Loading...
