Eaton PowerXL DH1 - Figure 25. DG1 Static IP Mode

37
EtherNet/IP On-Board Communications
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Manual IP address configuration
Using the PowerXL drive keypad
Using the drive keypad to set the IP Address manually.
1. Select IP addressing mode as Static IP. Static IP mode
configurations will be loaded.
ote: N Change in IP address mode will require PowerXL to
power cycle to get this change effective. Also ensure
device MAC address (Keypad menu. P20.3.5)
Figure 25. DG1 Static IP mode