165
BACnet/IP On-Board Communication— PowerXL DH1
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Prepare to use BACnet/IP through RJ45 port
1. Open the cover of the AC drive.
WARNING
The relay outputs and other I/O-terminals may have a
dangerous control voltage present even when drive is
disconnected from mains.
2. Connect Ethernet cable.
3. Remount the AC drive cover.
ote: N When planning the cable runs, remember to keep the
distance between the fieldbus cable and the motor
cable at a minimum of 11.81 in (30 cm).
RJ45 port LED indications
RJ45 LED
1. Ethernet Link Status
2. Ethernet Link Speed
To Next Page
Loading...
