M3A Vital Signs Monitor User Manual Introduction
- 18 -
Parameter Area (①)
Parameter area is on the upper part of main interface, and following parameters are displayed:
SpO
2
:
SpO
2
(Unit: %)
PR (Pulse Rate, Unit: BPM).
SpO
2
alarm limit
NIBP:
SYS, DIA, MAP (Unit: mmHg or kPa; 1 mmHg=0.133 kPa).
Pulse Rate (Pulse Rate, Unit: BPM)
TEMP:
Temperature (Unit: ℃ or ℉).
The PR signal from SpO
2
measuring takes priority to be displayed.
Waveform/Trend List (②)
It can display SpO
2
waveform, NIBP multi-group review, and trend list or trend graph.
Information Area (③ ④)
The Information Area is at the right and bottom parts of the screen, displaying operating status of
the monitor and condition of the patient.
The information area contains the following data:
Patient type and ID;
NIBP measuring mode;
Signs indicating the battery or mains power supply status;
Current time;
Alarms and prompts.
Alarm Indicator and Alarm Status
－ In normal conditions, the alarm indicator does not light.
－ When an alarm is generated, the alarm indicator lights or flashes. The color of light represents
the alarm level. Refer to Chapter 5 Alarm for details.
－ Refer to relevant content of parameters for Alarm information and prompt.
Charging Indicator and Charging Status
To indicate the status of charging: when the battery is being charged, the light turns to yellow;
after the charge is finished, the light will be off.
To Next Page
Loading...
Need help?
General
