Chapter 51
| Multicast Routing Commands
PIM Multicast Routing
– 1207 –
PIM6 Shared Mode Commands
router pim6 This command enables IPv6 Protocol-Independent Multicast routing globally on
the router. Use the no form to disable PIM multicast routing.
Syntax
[no] router pim6
Default Setting
Disabled
ipv6 pim
trigger-hello-delay
Configures the trigger hello delay IC
show ipv6 pim interface Displays information about interfaces configured for PIM NE, PE
show ipv6 pim neighbor Displays information about PIM neighbors NE, PE
PIM-DM Commands
ipv6 pim graft-retry-interval Configures the time to wait for a Graft acknowledgement
before resending a Graft message
IC
ipv6 pim max-graft-retries Configures the maximum number of times to resend a
Graft message if it has not been acknowledged
IC
ipv6 pim state-refresh
origination-interval
Sets the interval between PIM-DM state refresh control
messages
IC
PIM-SM Commands
ipv6 pim bsr-candidate Configures the switch as a Bootstrap Router (BSR)
candidate
GC
ipv6 pim register-rate-limit Configures the rate at which register messages are sent by
the Designated Router (DR)
GC
ipv6 pim register-source Configure the IP source address of a register message to an
address other than the outgoing interface address of the
designated router (DR) leading toward the rendezvous
point (RP)
GC
ipv6 pim rp-address Sets a static address for the rendezvous point GC
ipv6 pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ipv6 pim spt-threshold Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
GC
ipv6 pim dr-priority Sets the priority value for a DR candidate IC
ipv6 pim
join-prune-interval
Sets the join/prune timer IC
clear ipv6 pim bsr rp-set Clears RP entries learned through the BSR PE
show ipv6 pim bsr-router Displays information about the BSR PE
show ipv6 pim rp mapping Displays active RPs and associated multicast routing
entries
PE
show ipv6 pim rp-hash Displays the RP used for the specified multicast group PE
Table 41: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General