Edge Technologies Minuteman 320 SE - Page 137

MINUTEMAN 320
130
REV 13.1:2020
F2 Fixed Parameter
Setting unit Range Suggested setup
mm/In 0~999 0.5 sec
Description:
Setting method:
Note:
Time pusher will continue to push bar after collet closes when in
automatic (Collet open speed and torque parameters are used).
Enter value required to continue pushing.
Adjust only for time difference between when lathe collet open signal is
lost to barfeed and lathe collet is fully closed.
Setting unit Range Suggested setup
Sec 0~999
Depend on cycle time of
workpiece
Description:
Setting method:
Note:
Amount of time that the cycle start is on before it shuts off
Enter the value needed for cycle start
If this parameter is set to 0, the cycle start latches until the
collet is closed
Setting unit Range Suggested setup
Sec 0~999 90%
Description:
Setting method:
Note:
This parameter is set by measuring the pusher length.
Measure from the prefeed pusher to the end of the pusher collet. Input
value into HMI
This allows to accurately measure long bars.