Edge Technologies Minuteman 320 SE - Cont Feed off; Demo Mode on; F3 System Function

MINUTEMAN 320
131
REV 13.1:2020
F3 System Function
Setting unit Range Suggested setup
On / Off On / Off Off
Description:
Demo Mode
Setting method:
Note:
Sets the barfeed to demo mode. (Set collet open and bar change to on)
Select to turn demo mode on or off.
Not for use by end user
Setting unit Range Suggested setup
Sliding / Fixed Sliding / Fixed Sliding
Description:
Swiss
Setting method:
Note:
Sets the type of lathe, sliding headstock or fixed headstock.
Enter the value needed for application type.
This setting basically disables the synchronization clutch when in fixed
headstock mode
Setting unit Range Suggested setup
Off Off Off
Description:
Cont Feed Off
Not used, saved for engineering testing
Setting unit
Range
Suggested setup
Bar / Roller Bar / Roller Bar
Description:
Bar Loader
Roller Loader
Setting method:
Note:
Special application setting
Enter the value required.
Roller loader is not generally used.