MINUTEMAN 320
86
REV 13.1:2020
5.7 Channel Set Components
Caution when changing channel set be sure the electrical power to
the bar feeder is off.
Warning proper channel set to material diameter is important.
Damage to the bar feeder and or the lathe may result.
Warning all channel sections must be in position prior to operation.
Machine damage will occur if channel sections are not in the proper
position.
The channel set on the Minuteman may be changed to a variety of sizes. It is important to note
the material diameter to be used in the bar feeder fits in the proper channel set. Channel set
components are specific to each channel set. Contact Edge Technologies for additional channel
sizes and sets.
To Next Page
Loading...
