MINUTEMAN 320
24
REV 13.1:2020
plug, and check that the voltage of the lathe is proper and does not fluctuate beyond safe
operating voltage.
IF the voltage is in the wrong pin location then simply move the bar feeder voltage to the correct
location in the plug. If the voltage is too high or varies too much on the lathe the customer may
need to have an electrician come out. The may also be a need for a transformer between the
bar feeder and lathe. IF this is the case, DO NOT ATTACH BAR FEEDER.
Use the lathe manual when they are available. The more information available, the easier
and better trouble shooting will become.
To Next Page
Loading...
