MINUTEMAN 320
ii
4.7 Axial Shifting …………………………………...…………….… ……………... 39
4.8 Setting Axial Track Synchronization Switches …………………………….. 45
4.9 Change Axial Swiss Mode to Chucker Mode ……………………………….. 47
4.10 Change Chucker Mode to Swiss Mode ……………………………………… 48
4.11 Axial Track Programing Tech Tip …………………………………………….. 49
4.12 Nose Block Alignment …….…………………………………………………… 50
4.13 Anchoring…..………………………………………………………………….… 52
4.14 Installation Components ……………………………………………………… 53
4.15 Spindle Liner...…………….…….……...………………………………….…… 54
4.16 Telescoping Nose …………………………………………………………….... 55
4.17 Hard Nose ……………..…………………………………………….…………. 60
4.18 MAVD Installation ……………………………………………………..………. 61
4.19 AVD Centering …………………………………………………………………. 64
4.20 Synchronization Connecting Rod ………………………………..…………… 66
4.21 Drip Pan ………………………………………………………………………… 69
4.22 Hardnose Oil Collector ………………………………………………………... 71
5. Systems and Adjustments
5.1 Bar Feeder Component Locations…..………………….……….……………. 72
5.2 Magazine Adjustment …….……………………………………….….............. 73
5.3 Movable Anti-Vibration Device/MAVD/AVD Adjustment ..........…….…...... 75
5.3.2 MAVD/AVD Block Sets ……………..………………………………..……….. 79
5.4 AVD Roller/Block Replacement ………………………………………..…….. 71
5.5 Pusher Drive Belt …………….………………………………………………… 82
5.6 Synchronization System ………………………………………………………. 83
5.7 Channel Set Components ….……………………………………..………….. 86
5.8 Pre-Run Setup Card ……………………………………………………..……. 88
5.9 Pre-feed Pusher and Pusher …………………………………………….…… 89
5.10 Rotating Tip …………………………………………………………………..… 91
5.11 Channel Set Replacement ………………..…………………….…………..… 93
5.12 Material Measurement sensor/Cutting sensor ……………………………… 96
5.13 Gripper Assembly ……………………………………………………………… 97
5.14 Shuttle - Extraction / Introduction Cylinder …………...…………………….. 99
5.15 Procedure for Checking Bar Straightness ……………………....…...…..….. 100
5.15.1 Bar Stock Preparation ……………………………………………………….… 101
5.16 Vibration Troubleshooting Check List ……………….………………………. 102
6. Control Operation and HMI Description
6.1 HMI Operation Description ……………………………………….…………... 103
6.2 Handheld Pendant ………………………………………………..……………. 106
6.3 Power Up ……………………………………………………………………….. 107
6.4 Basic Movement Functions ……….………………………..……................... 108
6.4.1 Advance / retreat at low-speed ……………………………….………………. 108
6.4.2 Automatic work operation ……………………………………….…………….. 108
To Next Page
Loading...