MINUTEMAN 320
65
REV 13.1:2020
Use a long reach allen wrench to access the mounting
screws.
Caution lathe and bar feeder must be
powered on to adjust the AVD roller/block
settings.
Warning the correct spindle liner must
be installed in the lathe spindle according to
the pusher diameter. See parts requirments.
1. Remove any material from the bar feeder channel
and/or lathe spindle.
2. Using caution move the pusher into the lathe spindle
until bar feeder collet is 13mm from lathe collet.
3. Access the HMI to the F2 parameters menu.
4. Locate the First Anti-Vibration opening posistion paremter and record the current value.
Set to the value greater than the current pusher position.
5. Close the lathe collet.
6. Press the pre auto button on the pendant. AVD rollers should close on pusher.
7. Adjust the centering of the AVD via the adjustment screws.
8. Open lathe collet and AVD will release.
9. Move pusher home.
10. Access the HMI F2 menu once again and locate the First Anti-Vibration Opening position.
Place the pre recorded value from step 4.
11. Adjustmnent is complete.
12. Adjust roller settings for material diameter.
Adjustment screw
location similar to the
To Next Page
Loading...
