© Edwards Limited 2015. All rights reserved. Page 35
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A352-03-880 Issue B
7.4.1 Oil level sensor (ES65/ES100)
Figure 13 - ES65/ES100 oil level sensor
Fitting Instructions (refer also to Table 13).
1. Drain oil from pump.
2. Remove the blank plate and seal.
3. Clean the area where the oil level sensor (Figure 13, item 1) will be fitted.
4. Carry out a visual check on the sealing face of both the pump and the oil level sensor (1).
5. Secure using fixings provided.
Product Item Number
ES65/ES100 oil level sensor A352-66-810
To Next Page
Loading...
