© Edwards Limited 2015. All rights reserved. Page 39
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A352-03-880 Issue B
7.4.5 Oil level sensor (ES200/ES300)
Figure 17 - ES200/ S300 oil level sensor
Fitting Instructions (refer also to Table 13):
1. Drain oil from pump.
2. Remove the blank plate (Figure 17, item 2) and O-ring.
3. Clean the area where the oil level sensor (1) will be fitted.
4. Carry out a visual check on the sealing face of both the pump and the oil level sensor.
5. Secure using fixings provided.
Product Item Number
ES200/ES300 oil level sensor A352-77-810
To Next Page
Loading...
