A352-03-880 Issue B
Page 48 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
7.4.15 ITO800 inlet catchpot
Description as in Section 7.4.13.
7.4.16 ITM 100 high-capacity inlet dust filter
The ITM high-capacity inlet dust filter is used for applications that require fast pumpdown with high loads of dust and
grit, which would rapidly clog the equivalent ITF inlet dust filter element.
The dust filter operates in a similar way to the catchpot described in Section 7.4.13. In addition, the pumped gas
passes through the high-capacity dust filter element (Figure 26, item 8).
The filter material is stainless steel mesh which can be made wet with oil for greater dust adhesion in those
applications where the oil sealed vacuum pumps that can tolerate oil carryover are used, e.g., oil sealed rotary vane
or piston type pumps. The filter should not be oil wetted when using oil free dry pumps.
7.4.17 ITM 300 high-capacity inlet dust filter
Description as in Section 7.4.16.
7.4.18 ITM 800 high-capacity inlet dust filter
Description as in Section 7.4.16.
7.4.19 Inlet and exhaust connectors - available to fit to existing systems
Product Item Number
ITO800 inlet catchpot
o
A441-04-000
Product Item Number
ITM100 inlet dust filtero A443-02-000
Product Item Number
ITM300 inlet dust filtero A443-03-000
Product Item Number
ITM800 inlet dust filter
o
A443-04-000
Product Item Number
1 ¼" BSPP female x 1" BSPP male A259-18-100
1 ¼" BSPP female x 1 ½" BSPP male A259-18-101
1 ¼" BSPP female x 2" BSPP male A259-18-102
1" BSPP male to 1" NPTP female A259-18-103
1 ½" BSPP male to 1 ½" NPTP female A259-18-104
2" BSPP male to 2" NPTP female A259-18-105
To Next Page
Loading...
